减振器流体计算的过程中遇到问题
减振器流场流体计算时出现如下提示是什么原因 求大神指导NEW BCD ORDER 4<< 776
NEW BCD ORDER 5<< 875
NEW BCD ORDER 1<< 74
NEW BCD ORDER 2<< 417
*** WARNING *** CODE ADF2710:
Neighbor cells of point 2100 are not connected properly in boundary
geometry 1. 6 neighbor cells are found, but only 3
of them are connected.
This could be an internal error or a wrong data file was used.*** WARNING *** CODE ADF2710:
Neighbor cells of point 3591 are not connected properly in boundary
geometry 1. 6 neighbor cells are found, but only 3
of them are connected.
This could be an internal error or a wrong data file was used.
*** WARNING *** CODE ADF2710:
Neighbor cells of point 4596 are not connected properly in boundary
geometry 1. 5 neighbor cells are found, but only 3
of them are connected.
This could be an internal error or a wrong data file was used.
*** WARNING *** CODE ADF2710:
Neighbor cells of point 5391 are not connected properly in boundary
geometry 1. 6 neighbor cells are found, but only 3
of them are connected.
This could be an internal error or a wrong data file was used.
问题二
和上述问题是在同一个模型中出现的，在计算过程中出现如下提示是什么原因应该如何处理 求指导
*** WARNING *** CODE ADF6069:
Current mesh could be invalid! The factorized diagonal 3.0050E-22 at
node (index) 2 is negative. 看不懂，你做的太高深了。 能问一下你的减震器做的怎么样了吗 本帖最后由 mygodsim 于 2015-12-24 17:43 编辑
减振器流固耦合计算关键是流场网格问题，要得到合格的流场网格，就必须对流场进行合理切割。
如果流场网格不合格，计算过程就会遇到各种问题。
c:aaa.jpg
mygodsim 发表于 2015-12-24 17:41
减振器流固耦合计算关键是流场网格问题，要得到合格的流场网格，就必须对流场进行合理切割。
如果流场网格 ...
能交流一下吗、？:)
页:
[1]